Cisco Nexus 7000 Series Ethernet Module N7K-F248XP-25E Overview
Cisco Nexus 7000 Series Ethernet Module N7K-F248XP-25E is a genuine modular capacity expansion product from Cisco, a global name in networking whose platforms are used by enterprises, service providers and data-center operators alike. Belonging to the Cisco Nexus 7000 Series family, the N7K-F248XP-25E unit is built to the original factory specification, so it integrates with existing Cisco deployments predictably and behaves exactly as the platform documentation describes. In the network, it is installed into a compatible chassis slot, where it works alongside the supervisor and line cards to extend the platform’s capabilities.
This unit follows the original factory specification for the Cisco Nexus 7000 Series family, covering its intended role without compatibility surprises. Standard mounting, cabling and management practices apply, and it interoperates with surrounding hardware using the same procedures as other Cisco equipment already deployed in the network.
Typical deployments include adding ports and performance to existing chassis systems, modernizing legacy platforms with compatible line cards, and mixing copper, fiber and high-speed uplinks in one chassis. Organizations commonly source it for refresh programs, capacity expansion and spares management, keeping a tested unit on hand so outages stay short and replacements are predictable. The factory detail for this unit reads: “Cisco Nexus 7000 Series Ethernet Module N7K-F248XP-25E”. This makes it a practical choice when original-spec hardware is required at a predictable cost.
Every unit at LinkNewNet is inspected and tested before dispatch, and stock is graded, cleaned and verified for correct operation, including port status, console access and firmware state. Our warranty coverage and responsive technical support protect the purchase after it arrives, and our team can confirm revision levels and software compatibility before you order. For volume requirements we also offer configuration checks and staged delivery options.
Contact our sales team for current availability, lead time and shipping options for the N7K-F248XP-25E. We respond quickly with stock status and a firm quote, so you can plan the refresh or expansion with confidence.
Key Specifications
Applications
Capacity Expansion
Add ports and performance to existing chassis.
Upgrade Path
Modernize aging platforms with compatible modules.
Flexible I/O
Mix copper, fiber and high-speed uplinks.
Buying a Pre-Owned N7K-F248XP-25E
Verify the unit is tested, firmware confirmed, and condition documented. Every unit is fully tested and warranty covered. Contact our team for current stock and availability.
| N7K-F248XP-25E | |
| Product list | |
| Product code | N7K-F248XP-25E |
| Power cable | No |
| Button | No |
| Product parameters | |
| Software | Cisco NX-OS Software Release 6.2.2 or later |
| Connectivity | 48 ports of 1 and 10 Gigabit Ethernet (Small Form-Factor Pluggable [SFP] or Enhanced SFP [SFP+] optics modules) |
| Front-panel LEDs | Status： Green (operational) Orange (module booting) Red (fault) Link： Green (port enabled and connected) Orange (port disabled) Off (port enabled and not connected) Blinking green and orange in conjunction with blue ID LED (port flagged for identification; beacon) ID： Blue (operator has flagged this card for identification; beacon) Off (module not flagged) |
Interfaces | XML Scriptable Command-Line Interface (CLI) Cisco DCNM GUI |
| Features | Cisco Nexus 7000 Series Ethernet Module N7K-F248XP-25E |
| Introduction | The Cisco Nexus 7000 F2e-Series Fiber Module is a low-latency, high-performance, high-density 10 Gigabit Ethernet module designed for mission-critical data center networks. Up to 768 wire-rate 10 Gigabit Ethernet ports are supported in a single system through the use of the Cisco Nexus 7000 18-Slot Switch chassis, providing the highest-density of wire-rate 10 Gigabit Ethernet ports on the market. |
| Physical specifications | |
| Width | 55.6 CM |
| Height | 4.4 CM |
| Depth | 38.9 CM |
| Weight | 7.2 KG |
| Product compatibility | |
| Supported | Cisco Nexus 7000 4-, 9- 10-, and 18-Slot Switch chassis. |
N7K-F248XP-25E - Module Notes
This N7K-F248XP-25E line card/module variant is designed for the chassis slot type and fabric requirements of its platform family. Verify the slot compatibility, supported forwarding modes, and firmware version required for this specific SKU before ordering.
For capacity expansion, confirm the port density, uplink type, and any software feature dependencies of this module. Our team can verify revision levels and platform compatibility before dispatch.
Each N7K-F248XP-25E module is inspected, tested and verified for correct operation before leaving our facility, including port status, management access and firmware state.
